This page is here to be used as a pictorial guide for the Basic machining setups of the RMC engine castings.
The machining steps here are labeled as to match up with the steps shown in the RMC engine plans.

Note: These pictures are just one example of the setup process for machining of the engine castings & are shown using a standard lathe & verticle mill.


If assistance is needed for any machining process from milling & drilling to lathe work, Mr. Mark Meincke has a complete machine shop set up to help meet your model engine machining needs. He also manufactures` reproduction & custom parts for many gas engines. He is located on the web at; http://www.geocities.com/ottosideshaft. His contact information is as follows;

*Telephone = (440) 937-5630
*FAX = (440) 937-5650
*Postal Address = 34361 Schwartz Road, Avon, Ohio 44011
*E-mail = ottosideshaft@yahoo.com

Pictures of machining setups follow below: